User manual X10 MS14

[. . . ] You can set the Motion Sensor to turn the lights or cameras off after motion stops. You can set this for a preset time of 1, 2, 4, 8 minutes etc. , (see below for more details). The Motion Sensor also works with the CM11A TwoWay Computer Interface to initiate macros (routines) so you can set up a "coming home" routine which is initiated by the Motion Sensor as soon as it "sees" you. [. . . ] 3 seconds later the red light reports its delay setting as follows: 1 blink for 1 minute. 3 seconds later the red light reports its delay setting, as listed above. Release and immediately press the Unit/Off button the number of times for the delay you want, as listed above. The red light then reports the setting with the appropriate number of blinks as above. To change the Unit Code that the Motion Sensor transmits: Press and hold the Unit/Off button (under the battery compartment lid) the red light flashes first and then blinks the current setting. Release and immediately press the button the desired number of times for the Unit Code you want to set. To change the House Code that the Motion Sensor transmits: Press and hold the House/On button (under the battery compartment lid) the red light flashes first and then blinks the current setting (once for A, twice for B, etc. ). Release and immediately press the button the desired number of times for the House Code you want to set (once for A, twice for B, etc. ). The Motion Sensor can send signals when it detects dusk and dawn so it can turn a light on when it gets dark and turn it off when it gets light (in addition to turning lights on when it detects motion). To have it turn a light on at dusk and off at dawn plug the light into an X10 Module and set it to the same Housecode as the Motion Sensor and to a Unit Code that is one number higher than the Unit Code of the module or camera that turns on when motion is detected. if the Motion Sensor turns on A1 when it detects motion, it will turn on A2 when it gets dark and turn it off when it gets light. If you use this feature, care should be taken to place the Motion Sensor where it sees plenty of sunlight during the day (such as near a window). If you place it in a dark corner it might not be able to tell the difference between day time and night time. Care should also be taken not to place the Motion Sensor near the light it is controlling, otherwise when the light turns on it might "fool" the Motion Sensor into thinking it's daytime, so it will turn the light off again!Note: If you use the Motion Sensor to control X10 wireless cameras, care should be take not to set any cameras to the code that the Motion Sensor sends at dusk and dawn (Unit Code +1). To set whether you want the Motion Sensor to transmit EVERY time it sees motion or only at night: Press the Unit/Off button once. 3 seconds later the Motion Sensor reports its dusk/dawn setting as follows: The red light blinks once if the Motion Sensor is set to detect motion at all times. The red light blinks twice if the Motion Sensor is set to detect motion only when it's dark. [. . . ] ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. LIMITED1-YEARWARRANTY X10. com, a division of X10 Wireless Technology, Inc. (X10) warrants X10 products to be free from defective material and workmanship for a period of one (1) year from the original date of purchase at retail. X10 agrees to repair or replace, at it's sole discretion, a defective X10 product if returned to X10 within the warranty period and with proof of purchase. [. . . ]