User manual X10 RT504

[. . . ] Note some Sensors use two AA batteries - follow the instructions that came with the Sensors. Set the switch inside to MAX (left) for doors, or MIN (right) for windows. Press and hold the button inside the Door/Window Sensor for 3-4 seconds and then release it. [. . . ] This initializes the Sensor and picks a random code that is used when it is registered with the Console. Replace the cover and place the magnet next to the Sensor (with the arrows aligned). If you are registering a Keyfob Remote: Press any button on the Keyfob remote. The Console acknowledges that it has been registered by beeping and displaying RMOT 1 SET. The display increments to RMOT 2 SET, etc. , as you register more remotes. Installing the Motion Detectors · Set the slide switch (on the back) to position 1 for instant triggering for maximum sensitivity, or position 2 to trigger only after two movements have been sensed. · Attach the Motion Detector to a wall at a height of 5 to 6 ft. , using the mounting bracket and screws provided. · Point the Motion Detector so that it looks slightly downwards. If you are registering Door/Window Sensors: 90° Some of the accessories available are shown below. See your owner's manual or visit www. x10. com for more information. Move the magnet away from the Door/Window Sensor. The Console acknowledges that it has been registered with a chime and by displaying ZONE 1 SET. 5-6ft ON MOTI CTOR DETE Initializing Motion Detectors Remove the cover on the front of the Motion Detector and install 2 AA alkaline batteries in the battery compartment. Install 4 AA alkaline batteries (not supplied) in the Console's battery compartment. Registering the devices All features (except Home Control) require access to the Menu mode. The display then shows ENTER PIN (Personal Identification Number) in the top line. The default PIN is 0000, see your owner's manual if you want to change this, but for now press 0000 on the keypad. After pressing a Menu Start up or down button and entering the PIN, the First Level Menu (INSTALL) is displayed. To select a menu option, press the up or down Menu Start button repeatedly to step through the menu items 1 through 9. To leave the First Level Menu, repeatedly press the Clear button. Installing the Door/Window Sensors · Set the DELAY slide switch (inside the Sensor) to MIN (for windows) to always trigger the alarm instantly, or to MAX (for doors) to trigger the alarm after a preset entry delay when the system is armed in the AWAY mode. · Attach the Door/Window Sensor to the wall using the mounting screws provided (replace the cover). · Fit the Door/Window Sensor as high as possible at the top of the door/window. [. . . ] · Attach the Door/Window Sensor to the wall using the mounting screws provided (replace the cover). · Fit the Door/Window Sensor as high as possible at the top of the door/window. · Make sure the arrows on the magnet and the Door/Window Sensor are facing each other and that they separate cleanly when the door or window is opened. [. . . ]