User manual X10 VK70A

[. . . ] 7 FINE TUNING YOUR SYSTEM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 FCC CAUTION THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. [. . . ] If you install the camera outdoors, make a small hole in your exterior wall and pass the low voltage power jack through it. Plug the XM13A's power supply jack into the socket on the adapter cable from the camera. Adjust the antenna if necessary to aim it in the direction of the TV that you will view the camera on. Set the Housecode dial to a letter between A and P that matches the Housecode dial on the X10 remote controls you want to use it with. This lets you turn the camera connected to the XM13A on and off by remote control (using X10 remote controls, sold separately). See the owner's manual supplied with X10 remote controls for more details. IF YOUR TV IS ALREADY HOOKED UP TO A DBS RECEIVER OR OTHER A/V DEVICE, OR IF YOUR TV DOES NOT HAVE A VIDEO IN JACK * You can also set the Unit Code for any group of 4 cameras to 5-8, 9-12, or 13-16. If a DBS Receiver or other A/V component is connected to the TV using A/V cables, you can connect the Video Receiver to the free LINE IN jacks on the component. 6 7 FINE TUNING YOUR SYSTEM TROUBLESHOOTING IF YOU DO NOT SEE A PICTURE ON YOUR TV: Check that the Receiver and the Camera are on the same letter channel (A, B, C, or D). On the Camera the switch is located under the rubber plug on the base of the unit. Make sure you replace the plug afterwards if you intend to use the camera outdoors. For single camera systems the power supply for the Camera will normally be on (it powers up on). For Multi-Camera systems you need to purchase a TM751 Transceiver for the remote control to be able to turn Cameras on. When you turn any one on, in a group of 4 on, the others in the group turn off. Check that all camera power supplies are set to the same Housecode as the Transceiver and remote control. If you are using the RCA jacks, make sure you are using the appropriate input mode for your TV, try pressing the A-B button or Video button on your TV's remote control to change the input mode (consult your TV's owner's manual, if necessary). If you are using a Coax cable (Model VR31A Receiver only), verify that the Receiver and the TV are on the same channel (3 or 4). If you connected the Receiver to a VCR and then connected the VCR to your TV, you might need to turn the VCR OFF to see the Camera's picture on your TV. Or you might need to turn the VCR on, AND set it to record the picture from the Camera, in order to see the picture on your TV. Or you might need to press the A-B button on your VCR's remote control. Consult your VCR's owner's manual from more information. The system usually works best with the "pip" on the Camera's antenna facing the flat side of the Receiver's antenna (see diagram below). Sometimes, however, reflections and other effects in the home may affect the signal so that some adjustment of either the Camera or Receiver antenna may be necessary to get the best the signal. If you have more than one Camera, sometimes pointing the Receiver's antenna up towards the ceiling works best. [. . . ] We recommend using a frequency on the other device that is farthest from channel A or D, depending on which side of the band the other device is transmitting. Otherwise you will need to discontinue use of the device while using the Cameras. X10. COM A DIV. (X10) WARRANTS ITS PRODUCTS TO BE FREE FROM DEFECTIVE MATERIAL AND WORKMANSHIP FOR A PERIOD OF ONE (1) YEAR FROM THE ORIGINAL DATE OF PURCHASE AT RETAIL. X10 AGREES TO REPAIR OR REPLACE, AT ITS SOLE DISCRETION, A DEFECTIVE X10 PRODUCT IF RETURNED TO X10 WITHIN THE WARRANTY PERIOD AND WITH PROOF OF PURCHASE. [. . . ]