User manual X10 WS4777

[. . . ] 3-Way Wall Dimmer Set Up and Operating Instructions Model WS4777 (WS477 + CS277) WS477 Master BLUE Common (to Live) BLACK BLUE RED Traveller wires RED CS277 Companion BLUE Common (to lamp) The WS4777 Wall Dimmer Set is designed to control incandescent only lights with a rating of between 40W and 500W. The switches included in the set are the WS477 Master Switch and CS277 Companion Switch. [. . . ] · Replace one of the existing wall switches with the WS477 Wall Dimmer (Master): Connect the common wire to the BLUE wire on the WS477 using a wire nut. Connect the two remaining "traveller wires" to the RED and BLACK wires on the WS477, using wire nuts. If one of the travellers is red connect it to the RED wire on the WS477. · Replace the other existing wall switch with the CS277 Companion Switch: Connect the common wire to one of the CS277's BLUE wires. Connect the traveller which you connected to the RED wire on the WS477 to the RED wire on the CS277. Connect the remaining traveller wire to the second BLUE wire on the CS277. Screw both switches into their wall boxes (don't replace the wall plates yet). Setting up and operating the Wall Dimmer Module: · Set the House Code dial to the same letter (A thru P) that you set on your X10 controller(s). · Set the Unit Code dial to an unused code (1 - 16) which can be controlled from any X10 controller. · Set the power on-off slide switch (under the push button) to the ON (center) position. [. . . ] X10 agrees to repair or replace, at it's sole discretion, a defective X10 product if returned to X10 within the warranty period and with proof of purchase. If service is required under this warranty: Call 1-800-442-5065, visit www. x10. com, or e-mail sales@x10. com. X10. com, a division of X10 Wireless Technology, Inc. [. . . ]