User manual ZIBRO LASER FF 55

[. . . ] Laser FF 55 3 4 1 TR MANUEL D'UTILISATION OPERATING INSTRUCTIONS GEBRUIKSAANWIJZING KULLANIM KILAVUZU 2 24 46 68 4 OPERATING INSTRUCTIONS Dear Sir, Madam, Congratulations with your purchase of the Zibro, the number one brand among movable heaters. You have purchased a first-class quality product, which will serve you for many years to come. Please read these Directions for Use first, to ensure maximum lifetime for your Zibro. Your heater comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort with your Zibro. Yours sincerely, PVG International B. V. [. . . ] Step 3: Setting the clock Important: The clock on the heater must always be set to the correct time. It is only possible to set the correct time, when the heater is connected to the mains and not burning. First press either of the two buttons to switch on the 40 Chapter 2, OPERATION function (the CLOCK light and the information display will start blinking). Next, set the hours using the button on the left ( hour) and the minutes using the button on the right ( min. ). When you hold down the button, the value will continue going up, until you release the button again. After approximately 10 seconds the blinking will stop and the setting will be locked. After switching off the heater, the clock time will be displayed. 5. However, the heat yield is controlled automatically in accordance with the room temperature registered by the temperature sensor. The current room temperature and the set temperature are displayed on the information display. The ON/OFF light starts to flash, after which the heater will switch on. perature using the button on the right ( min. ) to set the temperature to a higher setting and the button on the left ( hour) to lower the temperature. After approximately 10 seconds the light will stop blinking and setting will be locked. The available temperature settings range from 10C minimum to 32C maximum. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20C. The operating mode is automatically controlled in accordance with the room temperature detected by the room temperature sensor. The heater works in the "HIGH" operating mode until the room temperature has reached the desired level. the heater automatically switches to the "MED" or "LOW" operating mode in order to maintain the desired temperature. Step 3: The correct use of `SAVE' The `SAVE' function allows you to limit the temperature. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 2C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Switch off the function by pressing the SAVE button once again. After 9-15 minutes, the heater will automatically select the correct operating mode and the ON/OFF button will now be illuminated continuously. Room temperature: under 0C 11 minutes 0C - 15C 9 minutes 15C 8. 5 minutes If no flames are visible after the start-up period, the heater will deactivate and then restart automatically. If flames are still not detected, the heater will deactivate and will have to be restarted manually (error code E-2 on the information display). [. . . ] This does not indicate a problem. Chapter 3, ERROR MESSAGES CODE E-0 E-2 E-6 E-8 E-12 E-13 E-22 -- : -Hi INFORMATION Power interrupted. Burner thermistor malfunction Excess fuel in the burner Ignition failure three times No fuel. Room thermistor malfunction or disconnected. WHAT TO DO Re-ignite the heater Contact your dealer Contact your dealer Contact your dealer Clean the air filter and remove dust. Contact your dealer Contact your dealer Contact your dealer Refill removable tank. [. . . ]