User manual ZIBRO LASER56

[. . . ] Laser 56 3 2 6 4 > 1 MANUEL D'UTILISATION GEBRAUCHSANWEISUNG BRUGSANVISNING OPERATING INSTRUCTIONS ISTRUZIONI D'USO GEBRUIKSAANWIJZING 3 27 51 75 98 122 4 OPERATING INSTRUCTIONS Dear Sir, Madam, Congratulations with your purchase of the Zibro, the number one brand among movable heaters. You have purchased a first-class quality product, which will serve you for many years to come. Please read these Directions for Use first, to ensure maximum lifetime for your Zibro. Your heater comes with a 24-month manufacturer's warranty on all defects in material or workmanship. We wish you much warmth and comfort with your Zibro. Yours sincerely, PVG International B. V. [. . . ] Information display Displays the clock, set temperature, room temperature and error codes. Operating mode lights - indicate whether the heater is operating at the "HIGH", "MEDIUM" or "LOW" setting. - Indicate when the heater is operating and flash when the heater is in the cleaning mode. - Switch on when the heater is operated manually or in "NORMAL" automatic operation. - Switch on when the heater is "SET-BACK" setting of automatic operation. 91 Chapter 2, OPERATION 4. Prior to use Step 1: Open the valve(s) Screw the valve on the top of the removable tank open or open the valve for the external fuel tank and the fire safety valve of the heater (if present). Step 2: Start the fuel supply Carefully press the red unlocking button for one second to release the float in the fuel receptacle. The fuel receptacle only has to be unlocked when the heater is activated for the first time or after it has run out of fuel, or if the heater has not been used for an extended period of time. Unlocking may also be required if the fuel inlet pressure exceeds 2. 5 psi ( 0. 17 bar). Step 3: Adjust the clock Important: The clock on the heater must always be set to the correct time. Press the "HOUR" and the "MINUTE" buttons to adjust the hours and minutes. Pressing the "HOUR" or "MINUTE" button once will adjust the time by one unit (hours or minutes respectively). Holding the button down accelerates the adjustment of the time display. All clock and timer settings are deleted if the power is cut off for a period longer than 10 seconds. The information display flashes "PM 12:00" when the heater is switched off. Set the timer switch to the "NORMAL" setting after completing the clock adjustment. The current time is then displayed on the digital indicator. switch to "OFF" to change to "MANUAL" operation. Step 2: Switch the heater ON Press the ON/OFF button until "ON" is displayed. The current room temperature and the set temperature are displayed on the information display. The ON/OFF light starts to flash, after which the heater will switch on. The heater will not work if the room temperature is higher than the desired temperature setting. After 9-15 minutes, the heater will automatically select the correct operating mode and the ON/OFF button will now be illuminated continuously. [. . . ] Pressure on fuel supply is incorrect. Solution Insert the plug into the socket. Clean the protective cap on the ventilator, remove dust and obstacles. Adjust the pressure on the fuel supply to a maximum of 2. 5 PSI ( 0. 17 bar). Check/repair the exhaust pipe (Pay special attention to all the connections) Check/repair all the connections in the fuel supply pipe. [. . . ]