User manual ZIBRO MOONLIGHTER

[. . . ] For reasons of safety and to prevent soot build-up do not use the Moonlighter in a high wind. 5 metre from highly inflammable objects; take care when using the heater under awnings or canopies. Only use Class C1 paraffin fuel in accordance with BS2869 Part two, or equivalent. Your Zibro Kamin heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Plus. [. . . ] Once the wick has reached its proper height, the automatic extinguisher is fully engaged. The wick adjuster knob will now move freely left or right to adjust the flame. NOTE: If you have difficulty igniting the wick, push back the igniter lever very slightly to remove the igniter coil form direct contact with the wick. After having ignited the heater, always check whether the combustion Chamber ¿ is level, by sliding it slightly to the left and the right by its handle (fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes for the flame to become visible in the combustion chamber. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. The flame can be adjusted with the wick adjuster knob · Too low a flame may also be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (leave window or door ajar) (contact your dealer or replace the wick, refer to section L) Turn the wick adjuster knob counter clockwise until it stops (about 1/8 turn) (fig. After a few minutes continue turning counter clockwise until it stops (about a half turn). Within a few moments the flame will be completely extinguished and the heater will be off. If any malfunctioning cannot be solved from the directions below, please contact your Zibro Kamin dealer. After having refilled and replaced the fuel tank, wait for 30 minutes before igniting the heater. Use the handle ´ to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). Before you refilled the tank, the heater had burnt up almost all the fuel. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). It is, however, important that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. Under normal conditions, only three components are subject to wear: Do not dispose of old batteries along with the other domestic waste. THE WICK To extend the glass fibre wick life, you must occasionally let the heater burn until the tank is completely emptied and the heater extinguishes by itself. [. . . ] In case they offer no solution, please take the heater to your dealer for repair. * Highly inflammable substances may induce uncontrollable burning, causing flames to break out. Should this happen, never try to move the heater, but always switch off the heater immediately (refer to Section E). In cases of emergency you may use a fire extinguisher, but only a type B extinguisher: a carbon dioxide or powder extinguisher. [. . . ]