User manual ZIBRO P726

[. . . ] The plug must always be easily accessible when the device is connected. Have the electrical installation checked by a recognised expert if you are not sure that everything is in order. The airconditioner is a safe device, manufactured in accordance with CE safety standards. Nevertheless, as with every electrical device, exercise caution when using it. [. . . ] Symbols: Automatic Cooling Dehumidify Circulate air Heat (only by PH 733) High ventilator speed Average ventilator speed Low ventilator speed Without the remote control, the air-conditioner can be operated by using the button on the front of the device. PLACING BATTERIES IN THE REMOTE CONTROL Remove the battery cover by pressing the lips in and then pulling the cover toward you. Replace batteries with new batteries of the same type when the display becomes fuzzy or the signal deteriorates. If the airconditioner does not respond to the remote control, follow the following procedures: · And hold it down until after the beep signal after approximately 8 seconds. 3 The following functions can be selected with the mode button remote control. The following settings are possible in the cooling mode: · The ventilator speed can be adjusted by pressing the Automatic regulation of ventilator speed High Average Low -button The temperature can be set between 18°C and 32°C by pressing the buttons. Whether the desired temperature can actually be reached depends on the ambient conditions. DEHUMIDIFICATION When the dehumidification mode is activated, the transparent ring around the button on the front of the device · The dehumidification function can be used in different ways. 1) All models: Only connect the air exhaust hose µ to the air outlet ¿ and lead it outside, as when using the device in the cooling function with a single hose. The device will then dehumidify the air in the room and remove excess moisture through the air hose. 2) All models: Do not connect both the air supply ¾ and the air exhaust hose µ. Into the water drain Lead the other end to a drain or sink and insert the plug Do not connect both the air supply ¾ and the air exhaust hose µ. During the dehumidification, the ventilator speed speed changes automatically to medium. In the automatic mode, the condensed moisture is always removed through the air exhaust hose µ. Removing the rubber plug from the water drain ¸ will allow the water to drain out at this point. When the device is not being used in the (manual) dehumidification mode, the plug must be removed from the water drain ¹. CIRCULATION When the air circulation mode is switched on, the transparent ring around the button on the front of the device · In this mode, only the ventilator speed can be adjusted by pressing the Automatic regulation of ventilator speed High Medium Low HEATING MODE (PH733) When the heating mode is activated, the transparent ring around the button on the front of the device · emits a RED light. The heating mode can only be activated when the ambient temperature is below 27 °C. Depending on the outside temperature, the device will stop heating regularly in order to thaw ice that has accumulated. The lower the outside temperature, the more frequently this will occur. The transparent ring on the front of the device will flash RED/ORAGNE/GREEN while this is taking place. In this mode, the desired temperature can be set between 18 and 27°C. [. . . ] The guarantee does not apply to damage caused by actions that deviate from the instructions or negligence. The shipping costs of the airconditioner or parts and the related risk are always borne by the purchaser. Damage, caused by not using suitable Zibro filters falls outside the guarantee. To prevent unnecessary costs, we recommend that you always first read the instructions carefully. [. . . ]