User manual ZIBRO PX 738

[. . . ] PX 738 2 6 5 3 4 > 1 : BEDIENUNGSANLEITUNG BRUGSANVISNING INSTRUCCIONES DE USO MANUEL D'UTILISATION OPERATING MANUAL ISTRUZIONI D'USO GEBRUIKSAANWIJZING INSTRUKCJA OBSLUGI 4 20 36 52 68 84 100 116 2 ALLGEMEINE SICHERHEIT Aus Sicherheitsgrnden bitten wir Sie, die Bedienungsanleitung vor Inbetriebnahme sorgfltig zu lesen!Personen, die mit der Bedienungsanleitung nicht vertraut sind, drfen das Gert nicht bedienen. A. Nicht selbst reparieren. A 6 SIKKERHED GENERELT Ls denne brugsanvisning grundigt igennem af hensyn til sikkerheden!Personer, som ikke er fortrolige med brugsanvisningens indhold, m ikke anvende dette klimaanlg. [. . . ] The display on the remote control shows the set temperature. and NOTE! Whether the desired temperature can actually be reached depends on the ambient conditions. DEHUMIDIFICATION When the dehumidification mode is activated, the transparent ring around the button on the front of the device turns YELLOW. Dehumidifying mode (yellow) During the dehumidification, the ventilator speed speed is set automatically to medium. The buttons are inactive. When the air circulation mode is selected, the transparent ring around the button on the front of the device emits GREEN light. In this mode, the air is circulated and filtered but not cooled or dehumidified. In this mode, only the ventilator speed can be adjusted by pressing the -button: Automatic regulation of ventilator speed High Medium Low Fan mode (green) AUTOMATIC In the automatic mode , the device will cool, dehumidify or circulate depending on the ambient temperature. When the temperature in the room changes, the mode changes automatically in order to maintain the desired temperature as accurately as possible. The colour of the transparent ring around the button on the front of the device will change depending on the operating mode. NOTE! Negative ions are generated in every operating mode (automatic, cooling, dehumidification and circulation). In cooling and dehumidifying mode condensation water is discharged via the connection tube to the outdoor unit. By removing the rubber plug from the water drain , the water will run out here. Water must always be able to flow freely. Cooling 25C Dehumidify 18C Circulating 4 74 4 ADJUSTING THE TIMER You can use the timer function to set in advance when the airconditioner is to switch on or off. Switching off The timer OFF function can be set when the airconditioner is switched on: Press Set the number of hours desired (1-12) with the aid of Press and Switching on The timer ON function can be set when the airconditioner is switched off (stand-by): Press Set the number of hours desired (1-12) with the aid of Press on the remote and You can delete the set timer function by pressing the control. When the set time is at "00", the timer is switched off. When the Timer function has been set the light in the button on the front of the device will switch on. -button again in order TIP! The light of the display fades when the remote control has not been used for some time. This is reactivated when you touch any button. NOTE! The compressor has been set so that it starts functioning three minutes after the (re)start of the air conditioner. The compressor will be switched off when the room temperature is lower than the set temperature. When the room temperature is higher than the set temperature, the compressor switches on again. ATTENTION Avoid the remote control from getting wet. Remove it from the unit when condensation can occur. 4 75 D AIR FILTER This airconditioner is equipped with a 3-layer filter to purify the air circulated by the indoor unit. The airconditioners are supplied with a separately packaged 3MTM FiltreteTM filter and active carbon filter. These filters must be placed in accordance with the instructions before the airconditioner is used. 2 3MTM FiltreteTM filter to remove particles from the air that are detrimental to your health, such as pollen, bacteria, flakes of animal skin and dust. The activated carbon filter and the 3MTM FiltreteTM filter can be removed. 1 The mesh filter must be cleaned regularly with a vacuum cleaner in order to prevent blockage of the air flow. [. . . ] Clean the filter or replace it (see chapter D). Air inlet or exhaust is blocked. Remove the blockage. The device is noisy. The device is standing on an Place the device on an even uneven surface. Wait 30 minutes until the The overheating safety temperature has dropped feature has been activated. batteries are empty. The compressor does not work. The remote control does not respond. The signal of the remote control cannot be received by the unit. Restore the connection between the remote control and the air conditioner (see chapter C). Never attempt to disassemble or repair the device. Inexpert repairs invalidate the guarantee and can endanger the users of the device. 4 80 K GUARANTEE CONDITIONS The air conditioner is supplied with a 24-month guarantee, commencing on the date of purchase. [. . . ]