User manual ZIBRO R 45 C

[. . . ] If a particular room is smaller than the specified space, always leave a window or door slightly ajar ( 2. 5 cm). We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. Do not use your heater in cellars or other underground areas. Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your heater. SAFE TOP The heater is supplied with a safe top. In this way, the risk of harmful accidents at accidentally touching the top plate is considerably decreased. [. . . ] Close the lid. C IGNITING THE HEATER A new heater may give off some smells for a short while, when it is used for the first time. You should therefore provide extra ventilation or ignite the heater outside the living room. When you use the heater for the first time, first put the filled removable tank into J K place, and then wait approximately 30 minutes before you ignite the heater. Follow the same procedure when you have completely burnt up all fuel from the tank, and after the glass fibre wick has been replaced. Before igniting the heater, always check the fuel indicator to see whether the removable tank needs filling up. Follow the procedure below: 1 Turn the knurled wick adjustment knob clockwise to its stop (Fig. If you apply more pressure you may turn it slightly further; however, it will automatically return to the startposition. When you have set the wick to its highest position, this action will automatically activate the safety device. Release the ignition button as soon as a flame is visible in the combustion chamber . 4 54 If the heater has been used only a few times and the wick adjustment knob is not locked, first turn the wick adjustment knob (Fig. L) completely left, before putting the wick in the highest position for ignition (Section C). E After having ignited the heater, always check whether the combustion L chamber is level, by sliding it slightly to the left and the right by its handle (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. D THE BURNING OF THE HEATER After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Reinstall the wick height lock (Section F). H MAINTENANCE Your heater needs hardly any maintenance. It is, however, important that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. Under normal conditions, only three components are subject to wear: 1. Follow the locally applicable regulations regarding the disposal of domestic chemical waste. THE WICK To extend the glass fibre wick life, you must occasionally let the heater burn until the tank is completely emptied and the heater extinguishes by itself. The burn-out will cause some smells, so it is recommended that you take the heater outside of the living room. THE IGNITION COIL The ignition coil will last longer if you ignite in the right way. Replace the batteries on time and make sure you do not push down the ignition slide too forcefully. Within this period all defects in material or workmanship will be repaired without any charge. The following provisions shall apply regarding this warranty: 1 We expressly dismiss all other claims for damages, including consequential damages. 2 Any repairs or replacements of components within the term of warranty will not result in an extension of the term of warranty. [. . . ] 15 Put the wick holder chassis back into position. 13a 13b 1 4a 1 4b 16 Screw the four wing nuts hand tight. If the wick cannot be lowered completely it has not been placed correctly. Pull the knurled wick adjustment knob off the heater. 17a 17b 18 Put the cabinet back into position and tighten the three screws. Check that it is level by sliding it slightly to the left and the right by its handle. [. . . ]