User manual ZIBRO R 50 C

[. . . ] Distance between the air inlet and the wall must be a minimum of 250 mm. Distance between the air inlet and the wall must be a minimum of 250 mm. Distance between the air outlet and the wall must be a minimum of 500 mm. The diagram above is a simplified illustration of the unit and may differ from the unit that you have purchased. [. . . ] Note: In some models, the cover must be removed in order to connect the wiring. Connect the wires to the clamps on the terminal board in the following manner: 2. Place an approved circuit breaker between the power source and the unit for model R 50 C. Access cover for terminal board (inside) Outdoor unit Always connect the air conditioner to a separate power circuit. Refer to the diagram on the inside of the access cover for the connection of the wires. Note: All cables used must be approved in accordance with local regulations. Fit the drainage outlet and drainage hose (only for models with a heat pump). Condensation will drip off the outdoor unit when the indoor unit is operating in Heating mode. Fit a drainage outlet and a drainage hose in order to drain the water effectively. Fit the drainage outlet and rubber washer to the base plate of the outdoor unit (see fig. Installing and fitting the outdoor unit Bolt the unit to a level and solid base. Indoor temperature Less than 20 °C More than 26 °C 20 ­ 26 °C Operating mode DRY Desired temperature 18 °C 23 °C 23 °C The indicator will not change after the temperature has been increased by 2°C. The indicator will not change after the temperature has been lowered by 2°C. Note: It may occur that no air is expelled from the unit while it is in operation. The unit will not always start operating immediately after the mode has been changed. If you program the timer with the TIMER button upon leaving, it will be pleasantly warm when you return home. To activate the air conditioner at the desired time, follow the procedure specified below (the remote control and air conditioner are switched off): 1. Select the ventilator speed (low, medium or high) or automatic mode (only possible when the Feel, Cool or Heat mode is selected) by pressing the Fan button. The ventilator always operates in the Auto mode when the Dry mode is selected. Use the button to select the time at which the air conditioner must activate (between 0 and 10 hours can be set at every half hour ­ between 10 and 24 hours can be set at every hour). Press the Timer button again to delete the selected data from the memory. Note: If no buttons are pressed during the programming of the timer function, the remote control will switch off automatically after 10 seconds. [. . . ] Do not place obstacles in the path of the air expelled from the outdoor unit, this increases noise. 1 The safety feature deactivates the unit in the following cases: - When the function is stopped or changed while the unit is operating. - After the plug has been inserted in the socket and the unit has been immediately switched on. Press the ON/OFF button to restart after the unit has deactivated due to the operation of the safety feature. [. . . ]