User manual ZIBRO R19C

[. . . ] For each model the minimum size of space is specified in which you can use the heater safely, without additional ventilation (refer to Section K). If a particular room is smaller than the specified space, always leave a window or door slightly ajar (± 2. We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. In this way, the risk of harmful accidents at accidentally touching the top plate is considerably decreased. [. . . ] Release the ignition button as soon as a flame is visible in the combustion chamber ¿. After having ignited the heater, always check whether the combustion Chamber ¿ is level, by sliding it slightly to the left and the right by its handle ´ (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. If the flame remains low after the adjustment, the wick height must be adjusted (refer to Section F). Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section M) This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. After a period of time the combustion may no longer be high enough (Section D). 3 Take the plastic collar between your thumb and index finger and pull it out. This can be done in one way only - check the rear of the cap for the correct position. If adjustment of the wick height does not have the required effect, let the heater burn until all fuel has been used up (Section H). If the flame height is still too low and the wick is set on position 3, then contact your dealer, or replace the wick, refer to section M. If the flame gets too high after adjusting (Fig Q), the wick height lock should be placed one position lower again. If any malfunctioning cannot be solved from the directions below, please contact your dealer. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Use the handle ´ to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). Before you refilled the tank, the heater had burnt up almost all the fuel. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). [. . . ] 5 The warranty will only apply, when you present the original, dated proof of purchase, provided no changes have been made to it. Ensure that you are wearing gloves and that you have a container in Which to put the old wick. 12 Install the wick to the wick sleeve according to the allowed direction engraved on the wick sleeve. And then install the top of the stem into the groove of the wick sleeve (with wick) from right side, and left the stem to the end. [. . . ]