User manual ZIBRO R419C

[. . . ] If a particular room is smaller than the specified space, always leave a window or door slightly ajar (± 2. We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your heater. In this way, the risk of harmful accidents at accidentally touching the top plate is considerably decreased. [. . . ] Follow the same procedure when you have completely burnt up all fuel from the tank, and after the glass fibre wick has been replaced. Follow the procedure below: 1 Slowly push down the igniter slide » together with the flame regulator · At the same time you will activate the safety device. 2 Release the igniter slide as soon as a flame is visible at the bottom of the combustion chamber ¿. After having ignited the heater, always check whether the combustion Chamber ¿ is level, by sliding it slightly to the left and the right by its handle (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. The flame can be slightly adjusted with the flame regulator · Too low a flame may also be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (leave window or door ajar) (contact your dealer or replace the wick, refer to section L) This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater for more than 5 seconds. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. Let the heater burn at its lowest setting for approximately one minute. In cases of emergency: switch off the heater with the safety device ³ (Fig. If any malfunctioning cannot be solved from the directions below, please contact your Zibro Kamin dealer. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Use the handle ´ to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). Before you refilled the tank, the heater had burnt up almost all the fuel. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). Refer to THE RIGHT FUEL (Section 'What you need to know in advance'). It is, however, important that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. Under normal conditions, only three components are subject to wear: Do not dispose of old batteries along with the other domestic waste. [. . . ] 5 The warranty will only apply, when you present the original, dated proof of purchase, provided no changes have been made to it. 6 The warranty will not apply to damages caused by actions not in compliance with the Directions for Use, neglect, and the use of an incorrect type of fuel, or fuel past its use-by date. 7 Transportation costs and the risks involved during the transportation of the heater or heater components will always be the responsibility of the purchaser. In order to avoid unnecessary costs, we recommend that you always read the 'Directions for Use' carefully first. [. . . ]