User manual ZIBRO RCA66

[. . . ] We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. Only use Class C1 paraffin fuel in accordance with BS2869: Part 2, or equivalent. Your Zibro heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Extra or Zibro Kristal. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. [. . . ] Next, set the hours using the key on the Hour) and the minutes using the key on the right ( When you hold down the key, the value will continue going up, until you release the key again. After approximately 10 seconds the blinking will stop and the setting will be locked. 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. When the heater has been unplugged for more than 10 minutes (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. The light next to them indicates that these numbers The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The temperature setting can only be adjusted, when the heater is burning. ) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( hour) to lower the Seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged for more than 10 minutes (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Switch off the childproof lock by pressing the key and holding it down for more than 3 seconds once again. J: When the SAVE light lights up, the heater will automatically switch on or off in order to remain within a specified temperature range. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. activate the 'SAVE' setting by pressing the appropriate key. Without the 'SAVE' setting your heater will maintain the set temperature by Approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. When the indicator light FUEL lights up, it means that there is only fuel left for 10 more minutes. The count-down of the remaining heating time can be seen in the information display ¹ (Fig. Now you have two options: you remove the fuel tank and refill it outside the living room (section B) or you push the button EXTENSION . At the arrival of 10, you will hear an alarmsignal every two minutes, warning you to refill the removable tank. [. . . ] It is, however, important that you clean the air filter cap grid and the vent filter with a vacuum cleaner and the with a damp cloth, both on a weekly basis. 2 Remove the dirt by tapping the fuel filter upside-down against a hard surface. We recommend that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. When the power cord is damaged, it may only be replaced by an authorised fitter. [. . . ]