User manual ZIBRO RCA68

[. . . ] Your Zibro Kamin heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Plus. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. Always refer to your local Zibro Kamin dealer for the right fuel for your heater. This cover allows you to keep your hands clean when opening the fuel tank. [. . . ] Next, set the hours using the key on the left ( hour) and the minutes using the key on the right ( min. When you hold down the key, the value will F: When the CLOCK indicator light stops blinking, the setting has been locked to the indicated value. After approximately 10 seconds the blinking will stop and the setting will be locked. 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the stand-by position. When the heater has been unplugged for more than 10 minutes (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. Once the heater is burning, the The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. ) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. Activate the childproof lock by pressing the appropriate key and holding it down for more than 3 seconds. Switch off the childproof lock by pressing the key and holding it down for more than 3 seconds once again. J: When the SAVE light lights up, the heater will automatically switch on or off in order to remain within a specified temperature range. When this function is activated, the heater will automatically switch off, when the room temperature exceeds the set temperature by 3°C. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Without the 'SAVE' setting your heater will maintain the set temperature by Approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. When the indicator light FUEL lights up, it means that there is only fuel left for 10 more minutes. The count-down of the remaining heating time can be seen in the information display ¹ (Fig. [. . . ] When the power cord is damaged, it may only be replaced by an authorised fitter. At the end of the heating season, you must store the heater in a dust-free place, if possible in its original packaging. If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local regulations for the disposal of domestic chemical waste. When you start re-using the heater follow the instructions again (starting from section A and as specified). [. . . ]