User manual ZIBRO S1847

[. . . ] Varmetilstand The air conditioner draws in heat from the outdoor unit and releases it via the indoor unit during heating operation. When the outdoor temperature falls, heat drawn in by the air conditioner decreases accordingly. At the same time, heat loading of the air conditioner increases due to larger difference between indoor and outdoor temperature. If a comfortable temperature cannot be achieved by the air conditioner, it is advised to use a supplementary heating device. [. . . ] fAN SPEED Indicator: Press the FAN SPEED button to select the desired fan speed setting (Auto-Low-Med-High). Your selection will be displayed in the LCD window except the Auto fan speed. 2 for the purpose of clear presentation But during the actual operation only the relative functional items are shown on the display panel. Remove the battery cover on the back of the Remote Control by pulling it according to the arrow direction shown on the cover. Insert new batteries making sure that the (+) and (-) of battery are installed correctly. When replacing batteries, do not use old batteries or a different type battery. If you do not use the remote controller for several weeks remove the batteries. Replace the batteries when there is no answering beep from the indoor unit or if the Transmission Indicator light fails to appear. When the Air Conditioner is ready for use, switch on the power and the OPERATION indicator lamp on the display panel of the indoor unit starts flashing. The most comfortable temperature settings are between 21ºC to 28ºC. In the AUTO mode, the air conditioner can logically choose the mode COOL, FAN, HEAT and DRY by sensing the difference between the actual ambient room temperature and the set temperature on the remote controller. If the AUTO mode is not comfortable for you , the desired mode can be selected manually. If the AUTO mode is not comfortable, you may manually override the settings by using COOL, DRY, HEAT (HEAT PUMP units only), or FAN ONLY modes by pressing button Push the v or w button ( are 28ºC or below. The operation lamp lights and the air conditioner starts to operate per your again to stop this unit operation. When in HEATING mode, the most comfortable settings The FAN ONLY mode cannot be used to control the temperature. The operation lamp lights and the air conditioner starts to operate in the DRY again to stop this unit operation. Use TIMER ON button on the remote controller to select a time you want to start your air conditioner. Do not put any object near air inlet or air outlet, as the efficiency of the air conditioner may be reduced and the air conditioner may stop running. Also the air stream must be allowed to reach the air conditioner unhindered. Clean the air filter periodically, otherwise cooling or heating performance may be reduced. Adjust the air flow direction properly otherwise, it might cause discomfort or cause uneven room temperatures. To set the horizontal air flow direction Perform this function while the unit is in operation. [. . . ] If a comfortable temperature cannot be achieved by the air conditioner, it is advised to use a supplementary heating device. The airconditioner is equipped with Auto-restart feature, when the power restores, the unit restarts automatically with all the previous settings preserved by the memory function. Stop the air conditioner immediately if one of the following faults occur. Operation indicator flashes 5 times, even after mains electricity has been disconnected and reconnected. [. . . ]