User manual ZIBRO SRE 179E

[. . . ] For comfortable and safe heating ensure that there is sufficient ventilation. Note: To avoid unexpected shut off, we recommend to put a door or window ajar when the heater is operating. For each Zibro model the minimum size of space is specified in which you can use the heater safely, without additional ventilation (refer to Section P). If a particular Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your Zibro. room is smaller than the specified space, always leave a window or door slightly ajar ( 2. 5 cm). [. . . ] Use the key (Nhour) to set the hours and the key (Mmin. ) to set the minutes (interval of 5 minutes). 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. 4 The timer will ensure that the room will have been heated to approximately the required temperature at the set time. H: The TIMER indicator light indicates that the timer function has been switched on. G H In case of any malfunctioning the information display will tell you what is the matter. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). Press the button once to clear the timer setting. SWITCHING OFF THE HEATER There are two ways to switch off the heater. 2 Press the TIMER key , when you want to switch off the heater and ignite it again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). THE INFORMATION DISPLAY The information display not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: CODE INFORMATION Temperature within the heater too high. Clean filter Contact your dealer. efefeeee- 0 0 1 1 2 5 6 7 e- 8 e- 9 4 55 -- : -- + -- : -- + e-11+ The heater has been in operation continuously for a period of 69 hours and has turned itself off automatically. Ventilate better. Always contact your Zibro dealer for any malfunctioning not listed above. AUTOMATIC DEACTIVATION This heater is fitted with a safety system that ensures that it switches off automatically after 69 hours continuous operation. If desired, you can switch the heater on again by pressing the button (see Section D). AUTOMATIC CLEANING MODE When the heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. The display will show the autocleaning code cl:05 running back to cl:01. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. By pushing this button, the remaining heating time will extend to 90 minutes. At the arrival of 10, you will hear an alarm signal every two minutes, warning you to refill the removable tank. The fuel indicator will blink, while four lines (--:--) are blinking in the information display. Once the heater has used up all its fuel and extinguished, it will take some time, after the refill, before the heater is completely ready for use again. K: When the FUEL indicator has appeard, the information display will show the number of minutes of fuel left in the tank. L THE 'VENT' INDICATOR When there is insufficient ventilation in the room, an intermittent buzzer will be heard (approximately once each 30 seconds) and the VENT indicator will be blinking. When this signal is given, ensure that the ventilation of the room is improved (e. g. by opening a door or window a little more), to avoid that the heater shuts off. When the ventilation of the room is improved, the VENT indicator and buzzer will be deactivated. When there is still insufficient ventilation, the heater shuts off automatically. After improving the ventilation of the room blinking and VENT indicator ( (e. g. [. . . ] Deutschland GmbH Bahnhofstrasse 150a D 48712 GESCHERE +49 (0) 2542 917560 tel: fax: +49 (0) 2542 917568 email: info@kb-deutschland. de e BELGI PVG Belgium NV/SA Industrielaan 55 2900 SCHOTEN tel: +32 3 326 39 39 fax: +32 3 326 26 39 email: pvgbelgium@zibro. com q SCHWEIZ PVG Schweiz AG Salinenstrasse 63 4133 PRATTELN +41 61 337 26 51 tel: fax: +41 61 337 26 78 email: pvgint@zibro. com 2 DEUTSCHLAND K. B. Deutschland GmbH Bahnhofstrasse 150a D 48712 GESCHERE +49 (0) 2542 917560 tel: fax: +49 (0) 2542 917568 email: info@kb-deutschland. de 6 DANMARK Appliance A/S Gefionsvej 7 DK-3400 HILLERD tel: +45 70 205 701 fax: +45 70 208 701 email: appliance@appliance-group. com 5 ESPAA PVG Espaa S. A. San Jos de Valderas II Comunidad "La Alameda" C/ Aurora Boreal, 19 28918 LEGANS (Madrid) tel: +34 91 611 31 13 fax: +34 91 612 73 04 email: pvgspain@zibro. com 3 FRANCE PVG France SARL 4, Rue Jean Siblius B. P. 185 76410 SOTTEVILLE SOUS LE VAL tel: +33 2 32 96 07 47 fax: +33 0 820 34 64 84 email: pvgfrance@zibro. com SUOMI Appliance A/S Gefionsvej 7 DK-3400 HILLERD tel: +45 70 205 701 fax: +45 70 208 701 email: appliance@appliance-group. com FIN FIN 4 UNITED KINGDOM Scott Brothers Ltd. [. . . ]