User manual ZIBRO SRE139E

[. . . ] Note: To avoid unexpected shut off, we recommend to put a door or window ajar when the heater is operating. For each model the minimum size of space is specified in which you can use the heater safely, without additional ventilation (refer to Section O). If a particular room is smaller than the specified space, always put a window or door slightly ajar (± 2. We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. [. . . ] ) to set the temperature to a switch on the function (the °C mark and 4-digit ¸ will start blinking). Next, adjust the temperature using the key on the right ( Higher setting and the key on the left ( After approximately 10 seconds the °C mark and 4-digit will stop blinking and the setting will be locked (Fig. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Button ¹ and then the TIMER key To set the time at which the heater must ignite. Hour) to set the hours and the key on the right Use the key on the left ( 3 After approximately 10 seconds the 4-digit will show CLOCK again and the When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). , when you want to switch off the heater and ignite it Again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). The information display ¸ not only serves as an indicator of the (set) time and temperature (sections C, E, and F), it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: CODE INFORMATION Temperature within the heater too high. The heater has been in operation continuously for a period of 48 hours and has turned itself off automatically. In case of any malfunctioning the information display will tell you what is the matter. This heater is fitted with a safety system that ensures that it switches off automatically after 48 hours continuous operation. If desired, you can switch the heater on again by pressing button ¹ (see section D). When the heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. the display will show the autocleaningcode cl 05 running back to cl 00. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. The childproof lock can be used to prevent children accidentally changing the heater settings. [. . . ] When you start re-using the heater follow the instructions again (starting from section A and as specified). Take the following measures to avoid fuel leakage during the transportation of the heater: Some drops may leak from the filter; keep a cloth Your heater comes with a 24-month warranty starting on the date of purchase. Within this period all defects in material or workmanship will be repaired without any charge. The following provisions shall apply regarding this warranty: 3 The warranty shall no longer apply, when the heater has been modified, Non-original parts have been used, or when it is repaired by third parties. [. . . ]