User manual ZIBRO SRE151

[. . . ] Only use Class C1 paraffin fuel in accordance with BS2869; Part 2, or equivalent. Your heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Extra or Zibro Kristal. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. Only this cap ensures trouble-free transportation of the heater after use. [. . . ] After approximately 10 seconds the 4-digit will stop blinking and the E: When the 4-digit stops blinking, the setting has been locked to the indicated value. 5 minutes after switching off the heater, the information on the display will disappear and the heater will automatically switch into the standby position. When the heater has been unplugged (or after a power failure), the time needs to be set again. When used for the first time, a new heater may give out a smell for a short while. The light next to them indicates that these numbers refer to the temperatures (Fig. The actual room temperature is indicated below ROOM, while the temperature setting is indicated below SET. The latter can be changed with the adjustment keys (refer to Section E). The temperature setting can only be adjusted, when the heater is burning. ) to set the temperature to a switch on the function (the °C mark and 4-digit the temperature using the key on the right ( higher setting and the key on the left ( After approximately 10 seconds the °C mark When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the button and then the TIMER key will start blinking. Subsequently, when the room temperature has dropped again to the set temperature, the heater will automatically switch on again. Switch off the function by pressing the SAVE key once Without the 'SAVE' setting your heater will maintain the set temperature by approximation as well, by adjusting its heating capacity. 'SAVE' is an economy setting, which you can use when, for instance, you are not present in the room or to keep it frost-free. J: When the FUEL indicator has appeard, the information display will show the number of minutes of fuel left in the tank. When the FUEL indicator appears, there is enough fuel left for another 10 minutes of heater use. The count-down of the remaining heating time can be seen in the information display (Fig. Every two minutes an alarm signal is sounded, warning you to refill the removable tank. The FUEL indicator will blink, while four lines are blinking in the information display. Once the heater has used up all its fuel and is extinguished it will take some time, after the refill, before the heater is completely ready for use again. When there is insufficient ventilation in the room, an intermittent buzzer will be heard (approximately once each ten minutes) and the VENT indicator will be lit. When this signal is given, ensure that the ventilation of the room is improved (e. [. . . ] When you start re-using the heater follow the instructions again (starting from section A and as specified). Take the following measures to avoid fuel leakage during the transportation of the heater: 1 Let the heater cool down. Your heater comes with a 24-month warranty starting on the date of purchase. Within this period all defects in material or workmanship will be repaired without any charge. [. . . ]