User manual ZIBRO SRE152

[. . . ] Only use Class C1 paraffin fuel in accordance with BS2869; Part 2, or equivalent. Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your heater. Your heater has been designed for use with high-quality water-free pure paraffin oil, such as Zibro Plus. Lower quality fuel may result in: increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. [. . . ] ) to set switch on the function (the TEMP light next to the information display blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( Seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the button and then the TIMER key immediately after that. The TIMER light and the information display 2 Use the adjustment keys Use the key on the left ( To set the time at which the heater must ignite. Hour) to set the hours and the key on the right 3 After approximately 10 seconds the information display will show CLOCK again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). 2 Press the TIMER key , when you want to switch off the heater and ignite it Again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). The information display not only serves as an indicator of the (set) time and temperature (sections C, E, and F), it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: CODE INFORMATION Temperature within the heater too high. In case of any malfunctioning the information display will tell you what is the matter. The heater has been in operation continuously for a period of 48 hours and has turned itself off automatically. This heater is fitted with a safety system that ensures that it switches off automatically after 48 hours continuous operation. If desired, you can switch the heater on again by pressing (see section D). When te heater has been burning continuously for two hours at its highest The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. [. . . ] Take the following measures to avoid fuel leakage during the transportation of the heater: 1 Let the heater cool down. Some drops may leak from the filter; keep a cloth Your heater comes with a 24-month warranty starting on the date of purchase. Within this period all defects in material or workmanship will be repaired without any charge. The following provisions shall apply regarding this warranty: 1 We expressly dismiss all other claims for damages, including consequential damages. [. . . ]